473196A
Nokia FZQE 473196A. Remote radio unit for Requires verification from the equipment nameplate (Requires verification from the equipment nameplate); 2T2R (family-level estimate); output Estimated 2 × 40 W (80 W total). Compatible baseband: Flexi System Modules ESMB, FSMD, FSME or FSMF; FBBA/FBBC capacity extension where required. Required modules and boards: FSMD/FSME/FSMF/ESMB system module; FBBA/FBBC capacity extension when required; FTIF transport where applicable; FPFD/FPFH/PFA power; FSAH alarm module; fan/cooling accessory where specified. Fronthaul: SFP optical CPRI, LC duplex through the optical transceiver. RF interface: 7/16 DIN female (typical for Flexi RFM/RRH). Power: -48 V DC outdoor/site supply through Flexi power cable. Mounting: Pole, wall, floor/plinth or Flexi rack/cabinet mounting depending on module casing. Verification status: Mixed / revision check; Exact family kits confirmed; select FPKA/FPKC by RRH form factor and revision.
| Band | Requires verification from the equipment nameplate |
|---|---|
| Frequency | Requires verification from the equipment nameplate |
| TX / RX Configuration | 2T2R (family-level estimate) |
| Output Power | Estimated 2 × 40 W (80 W total) |
| Supported Standards | GSM/EDGE, WCDMA/HSPA, LTE/LTE-A; exact support depends on Flexi software release |
| Compatible BBU / Baseband | Flexi System Modules ESMB, FSMD, FSME or FSMF; FBBA/FBBC capacity extension where required |
|---|---|
| Required Modules & Boards | FSMD/FSME/FSMF/ESMB system module; FBBA/FBBC capacity extension when required; FTIF transport where applicable; FPFD/FPFH/PFA power; FSAH alarm module; fan/cooling accessory where specified. |
| Compatible Cabinets / Subracks | FMFA 470149A plinth/mounting system; FCOB 473240A outdoor cabinet; compatible Nokia site cabinet |
| Compatible Passive Antenna | Passive band-matched antennas with 7/16 DIN or 4.3-10 jumpers; AISG/RET where supported |
| RF Connector Type | 7/16 DIN female (typical for Flexi RFM/RRH) |
|---|---|
| Fronthaul Interface | SFP optical CPRI, LC duplex through the optical transceiver |
| Optical Form Factor | SFP / SFP+ |
| Optical Speed | CPRI 2.5 / 5 / 10 Gbit/s |
| Optical Connector | LC duplex; outdoor LC sealing kit/cable assembly where required |
| Optical Reach | 2–80 m predefined outdoor cable assemblies or longer SMF link with matched optics |
| Known Optical Part Numbers | Known cable assemblies: FUFAS 473288A 2 m; FUFBB 473304A 50 m; FUFBY 473334A 50 m; FUFDD 473905A 80 m. Known optics examples: 4807457 and 4807528; verify exact rate/fiber. |
| AISG / RET / Control | AISG/RET circular connector; service/alarm |
| Power Supply | -48 V DC outdoor/site supply through Flexi power cable |
|---|---|
| Power Connector Type | Vendor-specific 2-pole sealed -48 V DC Nokia Flexi connector; the exact shell depends on the FR/FX/FH/FZ generation |
| Required DC Power Cable | Nokia Flexi outdoor DC power cable with a factory-installed mating plug |
| Power Consumption | Estimated maximum 230 W |
| Installation Environment | Outdoor |
| Mounting Method | Pole, wall, floor/plinth or Flexi rack/cabinet mounting depending on module casing |
| Mounting Kit / Hardware | FPKA Flexi pole kit 471649A; FPKC Flexi pole kit 472821A; FMFA floor/wall/pole mounting kit 470149A. FMFA includes fixing plates and module-casing screws. |
| Known Mounting Kit PNs | 471649A FPKA; 472821A FPKC; 470149A FMFA |
| Fasteners / Fixings | FMFA: fixing plates, M5×8 and M5×12 screws; pole kit/clamps; grounding cable. Wall installation requires anchors sized for the loaded module. |
| Cooling | Passive heat-sink cooling; model-specific fan unit may be required |
| Cables & Connections | CPRI/eCPRI optical fiber cable; -48 V DC two-core power cable; protective grounding cable; RF jumpers from radio to passive antenna; AISG/RET cable when external antenna control is used; weatherproofing/sealing kit; Known Nokia fiber cable examples: FUFAS 473288A, FUFBB 473304A, FUFBY 473334A, FUFDD 473905A |
| Dimensions | 133 × 447 × 422 mm core; 133 × 492 × 560 mm with covers |
| Weight | 24.5 kg net |
| Operating Temperature | -40 to +55 °C |
| Data / Compatibility Status | Mixed / revision check; Exact family kits confirmed; select FPKA/FPKC by RRH form factor and revision |
|---|---|
| Region | Global / variant-dependent |
| Representative Countries | Country list cannot be determined until the exact band of this part number is confirmed |
| Battery / Shipping | No internal battery specified; Normally ships without a battery. Verify that no separate Flexi power-battery accessory is included in the shipment |
Frequency compatibility is shown separately from documented deployment or regulatory approval.
Each relation retains its evidence level. Family-level, platform-level and engineering-selection relations are not displayed as exact part-number compatibility.
Target part number(s): 471469A; 472181A; 471402A; 472109A; 083780A; 083833A; 084792A
Interface / role: Flexi baseband/system processing
Conditions: Flexi software release, RAT and CPRI option must match
Target part number(s): 473240A
Interface / role: Outdoor protection / housing
Conditions: Check loaded dimensions, thermal load and cable entry
Target part number(s): 471649A FPKA; 472821A FPKC; 470149A FMFA
Interface / role: Mechanical installation
Conditions: Exact family kits confirmed; select FPKA/FPKC by RRH form factor and revision
Target part number(s): Known cable assemblies: FUFAS 473288A 2 m; FUFBB 473304A 50 m; FUFBY 473334A 50 m; FUFDD 473905A 80 m. Known optics examples: 4807457 and 4807528; verify exact rate/fiber.
Interface / role: CPRI 2.5 / 5 / 10 Gbit/s
Conditions: Optical rate, wavelength, fiber type and budget must match both ends
Target part number(s): 472182A; 472797A; 472311A; 472301A; CS7136001; 472839A; AA24250LFPFA
Interface / role: Capacity, transport, alarm and power functions
Conditions: Select FBBA/FBBC, FTIF, FPFD/FPFH/PFA and FSAH according to site BOM
Target part number(s): External antenna PN selected by band, port count and gain
Interface / role: RF radiation and reception
Conditions: Match band, polarization, port count, connector and PIM rating
Send the manufacturer, model, part number, quantity and destination country. Requests may include equipment not yet listed in the catalog.